lan7500 usb 2.0 to ethernet adapter driver

Link partner advertised pause frame use: Symmetric Receive-only Link partner advertised link modes: 10baseT/Half 10baseT/Full Supported link modes: 10baseT/Half 10baseT/FullĪdvertised link modes: 10baseT/Half 10baseT/FullĪdvertised pause frame use: Symmetric Receive-only : Bus 01.Port 1: Dev 1, Class=root_hub, Driver=sw_hcd_host0/1p, ~ # ethtool eth1 : Bus 02.Port 1: Dev 1, Class=root_hub, Driver=sw-ehci/1p, 480M

: Bus 03.Port 1: Dev 1, Class=root_hub, Driver=sw-ohci/1p, 12M |_ Port 1: Dev 2, If 0, Class=Vendor Specific Class, Driver=smsc75xx, 480M

: Bus 04.Port 1: Dev 1, Class=root_hub, Driver=sw-ehci/1p, 480M : Bus 05.Port 1: Dev 1, Class=root_hub, Driver=sw-ohci/1p, 12M Software Configuration: I had to add in an extra t h ree lines for this new USB eth1 NIC to get it working on the Banana Pi, the lines in bold ~ # cat /etc/network/interfacesīus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hubīus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hubīus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hubīus 004 Device 002: ID 0424:7500 Standard Microsystems Corp. Top USB port has USB 2.0 to Gigabit Ethernet Adapter plugged in and plugged.into router Inbuilt 10/100/1000 NIC is not connected.

It can never reach 480Mbps, but it will be interesting to see how much throughput it can actually achieve.Īs usual, I have censored any identifying information about my local network or personal hardware. Banana Pi USB 2.0 'Gigabit' Ethernet Adapter throughput test I bought a cheap USB 2.0 to Gigabit Ethernet Adapter ( Maximum Data Transfer RateĤ80 Mbps according to the website), mostly because I wanted to see how it performed on a Raspberry Pi, so now I'm running the same tests on my new board the Banana Pi.

Lan7500 usb 2.0 to ethernet adapter driver